HomieRoomSensor/Readme.md

57 lines
1.3 KiB
Markdown
Raw Normal View History

2021-11-15 19:07:58 +01:00
# Homie Room Sensor
located in IKEAs Vindriktning
after this upgrade it will measure:
* air quality
* temperatur
* pressure
* altitude
2021-11-15 19:11:41 +01:00
The system can be powered by USB-C or Micro-USB, attached at ESP8266 board.
2021-11-15 19:03:27 +01:00
## Filesystem
### Configuration
Use the config-example.json from the host folder and create here a config.json file.
### HowTo upload
Start Platform.io
Open a new Atom-Terminal and generate the filesystem with the following command :
```pio run -t buildfs```
Upload this new generated filesystem with:
```pio run -t uploadfs```
### Command pio
Can be found at ```~/.platformio/penv/bin/pio```
# Hardware
ESP8266 version ESP12 was used.
The prototype was based on the Witty board
```
REST | TXD
ADC LDR | RXD
CH_PD | GPIO05
GPIO16 | BTN GPIO04
GPIO14 | GPIO00
GPIO12 RGB-G | GPIO02
GPIO13 RGB-B | RGB-R GPIO15
VCC | GND
USB
```
The following pins are used:
2021-11-15 19:07:58 +01:00
* GPIO4 PM1006 particle sensor
* GPIO2 WS2812 stripe out of three LEDs, replacing the orignal LEDs at front
2021-11-15 19:11:41 +01:00
* GPIO15 Red LED (optional)
* GPIO12 Green LED (optional)
* GPIO13 Blue LED (optional)
2021-11-15 19:07:58 +01:00
* GPIO14 I2C clock
* GPIO5 I2C data pin
2021-11-15 19:03:27 +01:00
2021-11-15 19:11:41 +01:00
# Bill of materials
* IKEA Vindriktning
* ESP8266 (e.g. Witty board)
* BMP280 sensor
* some wire
2021-11-15 19:03:27 +01:00
# Sources
* [https://github.com/amkuipers/witty Witty pinout]